FlashForge Dreamer: PVA Problem & Build Plate Jerking

3D Printers

Apr 14, '16

Ok, been a while, I know, and I fixed the build plate issue. It was getting caught in the side of the roll of filament. Kind of a dumb mistake. I lowered the temperature on the PVA extruder, but… it’s clogged, probably from when it was at 200 degrees Celcius. So, I have to unclog that basically… I…

FlashForge Dreamer: PVA Problem & Build Plate Jerking

3D Printers

Apr 4, '16

Thanks a lot, I’m going to try to find a way to fix the axis, or find something about some of the internal wiring.

FlashForge Dreamer: PVA Problem & Build Plate Jerking

3D Printers

Apr 4, '16

Let’s get to the point, I recently received and order of PVA filament from BuMat and was using with PLA to print something. Anyhow, my printer heats up the PVA filament to 240 degrees Celcius. Is that an appropriate temperature for PVA?? While printing, the PVA oozes out, and about 40% of the time,…

dual print issue with PLA and PVA

Materials

Apr 4, '16

I have a Dreamer too, and I’ve been experiencing the same problem. Only that my build plate goes berserk every time I cancel a print. It literally jerks up and down for 3 seconds before stopping, and I have to level it again. very annoying. must find a solution…