-
.
-
I have been suffering badly with the extruder insisting on traveling to either the front or the left edge, I cured this by turning the brim off. I then started to suffer with the print getting about half of the bottom level done before it decided to have a hissy fit in the extruder stepper motor. I…
-
I went to your link and followed the instructions. The only thing I think I changed was the name of the printer to Anet A8 now, if I plug a printer in now the program crashes and isists I shut it down?
-
thanks for the replies. ““In Repetier it says the receive cache size is 127 and somewhere I read if this is too fast take it down to 64” - Cache size isn’t speed !!!” I was assuming if the cache it was printing was too large it would take too long, if I slowed it down it would allow it time to pri…
-
I can’t find anywhere that indicates the baud rate in cura?
-
Yes port 18. If I go to config/printer settings the box ‘port’ shows com 18 when I connect the printer, if I put it on this com 18 or put it on auto it looks as if it has connected but I get the conditions described above. I now know the baud rate of the printer is 115200 and repetier is set to thi…
-
I can’t see how to turn raft off in cura?
-
thanks for leaving the post. I have just printed my first item and my second. The only problem was the ‘raft’? (is this the flat base that surrounds the whole piece that has to be peeled off when complete?) If so, while it was doing this in both cases it would do a small part of the surround and …
-
on the screen go to position go down to z position fast press the up button this is the manual control
