-
Level your bed each print. clean printing surface with alcohol use lithium grease on Z axis rods keep belts tight run some cleaning filament every filament change check all your stop files prior to printing using Netfabb or program of your liking. cut straight tip on filament prior to loading …
-
Hello. You have to change the settings in the lcd menu instead. Press the knob, go down and into Configuration-Extruder and change Control to PID. Then change DT/PID P to 9.3, PID I to 0.52 and PID D to 41.9 . Then go back one step and select Store to EEPROM. Then it should work better. Best regards…
-
I was struggling with the same problem on my duplicator i3 , and i have tried a lot stuff. But in my opinion abs juice (50%acetone, 50%ABS) works very well. The print will stick nicely on the print bed and you don’t have to change a lot of settings.
-
It’s helpful if you can provide a copy of the actual .stl you tried to print from your SD card.
-
Sounds like your stepper motor wires are reversed. Or you could fix it in the code. What slicer are you using?
-
Hi Anthony, The Duplicator I3 is based on the Reprap Prusa printer. With the only difference the printer is pre-assembled. The first edition has been shipped out by the factory in May 2015. The first printers had some shortcomings and the manufacturer adapted this. Now the printer has improved a lo…
