-
Marco, I’m in the DFW metroplex. Feel free to message me if you haven’t found a service yet.
-
Every delta, by definition, will be inconsistently manufactured as compared to the values in the firmware. There’s nothing wrong with the construction of his printer. His parts are simply deviated slighty from what would be assumed “perfect”. As far as the print you choose to calibrate with, it does…
-
Sometimes we knowledgeable people tend to over talk, and make things more compicated. Plain english, in case what these other good people said didn’t make since to you. Two things you need to do: 1) Properly adjust your steps per mm to make sure it prints at the CORRECT HEIGHT. All three values for…
-
I’m assuming it’s a ramps/mega setup. Did you download the appropriate drivers/program to access the arduino mega board?
-
have you made any progress in correcting your issues?
-
You may want to try printing at a lower temperature, and at slower speeds. Possibly something in the range of 185-205 for PLA.
-
What information are you looking for specifically? If you will have a working printer soon, once you really learn the process, you’ll be able to print all your own parts. Then it’s just a matter of sourcing your own parts.
-
Definitely understood, as all of my deltas are custom made by myself. But it seemed as if you were interested in starting with something non-standard, vs building/copying a delta from plans that are already out on the web. I was simply saying, start with what’s already made, then grow into something…
-
Strike one more, for your next phase in the US. Thanks for your efforts.
-
Wheels Pros Inexpensive to initially purchase Inexpensive to replace/repair Cons If not properly adjusted, can add to slop in motion wheels with knicks/dents can add to inaccuracy or poor motion Linear Rails Pros Very smooth operation Low parts count Easy assembly Adds ro rigidity of machi…
-
A few questions… Is this your first printer? Is this your first scratch build? Just for knowledge and moving forward… Know that there is NO THEORETICAL DIFFERENCE in how any of the deltas operate. They all perform the SAME way, based on the SAME calculations. The difference, is simply the hardwar…
-
How close to(in) Dallas? I’m located in the Mid-Cities area.
