My Printer (Da Vinci 2.0A) wont load PLA Filament. I bought original PLA from Xyz-Printing.
I switched the chip in the catridge but he didnt load.
Do I have to install something?
Please help o.o
Gray or blue sides? If gray you’ll need the updated extruder to run pla. If your machine is under a year old you can get it free from xyz.
My sides are blue
is this the new Version?
Yes you should be able to run pla. Do you have 2 cartridges of pla installed?
nope, have only one roll of pla.
do I Need a second one?
Is it possible to just remove the other one out of the plotter?
You can use just one but as you said the other slot needs to be empty. The machine expects 2 of the same or only 1 in the primary location (right hand slot).
Yes, you should have to instill a driver.
