FlashPrint

[Riveras5]

Question. What does it mean when there is a red outline on my print? (Please see Screenshot) Not sure if that is some kind of warning concerning that specific print. Any insight on this would be great. Thanks!

[Andrew_247]

Looks like the red is simply outlining the edges of the print.

[Andrew_247]

Here’s a thought… what’s the width of those walls? Maybe it’s showing walls that are too thin or something?

[bawvu97]

Did you receive an error message that there may be errors in the model and ask you if you wanted to fix or ignore?

[wirlybird]

What version of Flashprint? Is this STL available to test?

[Riveras5]

I’m using version 3.16.2, I’ll attach the STL so you can take a look. Thank you so much!
card_tray_-_small_cards_zombicide_v1.1.stl (163 KB)

[Riveras5]

I did get an error about repairing the model which I do, Funny thing is I only get the red outline with this print. Smaller print areas come out fantastic so far, it’s the larger ones I’m having issues with.

[FerrariDrafting]

Run it through autodesk netfab or simmilar…I had same thing and it didn’t print the surface layer on area shown in red.

[wirlybird]

I’ll try to check it out this evening.