Creator Pro no longer prints

[User_3978]

My Creator Pro always worked well. Recently, when I try to start a print, the bed raises, the carriage moves to the front-left (as usual), and then moves back toward the right-rear (as viewed from the front). But just before it would hit the back microswitch and the left microswitch, it plays a little tune and just stops.

When I go to the control panel, I get the option to UN-PAUSE. It then heats up and when it starts to print, it displays the message"

“entering PAUSE P-stop triggered”

But I’m doing nothing that should cause it to enter PAUSE. When I try to resume the print, I get the same message. Does anyone know what is going on?

[tabbott]

Are you printing from your computer or sd card? Which slicer do you use?

[Perry_1]

Time to start messing with your endstops and endstop cables to see if you can figure out which one has a short…

[alvingm]

Any chance you are printing via USB?

[User_3978]

Yes, I’m printing with USB.

[alvingm]

Try printing with SD card and check if you still having the same issues. FFCP has known issues when printing via USB

[User_3978]

Printing from computer. It doesn’t matter which slicer. All act the same - Replicator G, older versions of Makerware, etc.