Skip to main content
18 results for@georgeroblesjr #3d-printing
Advanced filters
Relevance
Relevance
Jul '16
-
Make sure your librarys have uno in it. It may be easier just to use Arduino 1.0.4 upto 1.0.6 as it is an Ardunio board and has the librarys installed...
Sep '16
-
Gonna say loose wire, or almost completely broken wire connector. Can check all wires, especially the wires on heat cartridge. The also check the MOSFE...
Sep '17
-
Sanguinololu board is not big on memory. If your trying to enable eeprom chitchat and other additional stuff, then the best way to reduce it is to not...
Oct '16
-
First off, Try out cheata filament from the makers of ninjaflex. It's a semi-rigid, semi-flexable filament designed for the Bowden setups and no change...
Jul '16
-
And your sure you checked the bearings? Both linear and roller for belt tensioner? Alignment of smooth rods/guide rail? (Including the upper and lower...
Jan '17
-
I can help via Skype. I charge fair prices. If you donate to me or my YouTube channel, then can work out something. We can share screens via Skype, I c...
Oct '16
-
So I'm the third George to answer, lol. Anyways, stepper driver current and acceleration are related. Higher current almost equals higher speeds. For t...
Oct '16
-
Send me an email and we can talk if your interested in just running the same setup. I have gt2560 rev a in stock. Online store is http://georges3dprint...
Oct '16
-
i would have offered same help as first guy but I charge for my support. Anyways, make sure your using Arduino ide 1.0.1 to 1.0.4 versions. The lcd and...
Sep '16
-
Yes, but with a hot nozzle if full of filament. However, 0.2 create a lot of back pressure on the nozzle. And also slows printing seen way down. So you...
Sep '16
-
I have yet to see anyone mention just try changing the baud rate on say repetier host. In printer settings. Start with one end and work your way throug...
Jul '16
-
Fdm more of a hollow objects without so much modification. The powder and resin types, one has to make part solid/ or incorporate a hole(s) to remove e...
Jul '16
-
Need to change firmware pin out tab.
Nov '15
-
If your good with machines, then either way is the same. Either way, you will still need to learn the firmware so that you can do upgrades. I have adde...
Dec '15
-
What board?
Jan '16
-
Dang it. I had the same idea. However, I have a different idea than you, but look great.
Nov '15
-
I have a very simple a quick solution when it comes to small cross section of printing. my YouTube videos show a bit. georgeroblesjr is my user. Add a...
Nov '15
-
Did you home everything yet? Most cases new people do not home the printer. Marlin main, has a list of g code just in case you don't know them all. I u...