Skip to main content
Skip to profile content
-
Hello, In Common there are no differences between the Filament-materials. PLA is better printable and is chemical more stable. ABS has a little bit higher Temperature, but under normal Conditions, this won’t make a difference, I think you are most likly asking about the transparency. Here is no …
-
Hello, Arduino is the choice, if your control should be fast and precise in the reaction and has not much Data to transfer. Raspberry is better on higher Data (like Streaming Videos, etc.) but less precise in the timing of the IO. Maybe a Combination of both might be a solution (Depending on what…
-
http://www.rf1000.de/wiki/index.php/Kalibrierung\_der\_z-Achse\_(für\_Anfänger)
