-
Sounds like there are a number of local folks that can help you with the design side as well as getting the case printed. When you are ready to get designing yourself, you may want to consider many of the free or freemium software out there that makes designing such a thing very easy. As an entrepre…
-
Many thanks for the extensive tips. The PVA is sealed in a pouch with desiccant. I’m hoping it will survive OK outside for a few hours. Calibrations are done - went well. I may try working with two colors of PLA first to test the nozzles, then swap out one for PVA.
-
So I’m about to begin experimenting with the Zmorph Dual Head Extruder, using PVA as a support for more complicated PLA prints. I’m going to jump right in based on tips that I can find on the internet, but I am hoping someone on the 3DHubs Zmorph channel might have some good suggestions on where to …
-
I finally performed the calibration last week after having hit and miss results with ABS printing. It was very easy to do and gave great insight into how flat and level the table is. Here is the interesting thing - after international shipping from Poland to the US, with all the bumps and knocks I’m…
-
I have to agree with the conclusions. I just started printing with PETG yesterday and I can see how it finds a sweet spot between ABS and PLA. The 1.75mm PETG I was printing with last night sticks to the heated bed (maybe a bit too much, I probably need to lower the temperature) and I am seeing none…
-
This thread is a few months old already but I wanted to document my recent experiences with ABS on the Zmorph. I’m printing 1.75mm Hatchbox ABS purchased through Anazon, using the 245C / 100C temperatures (nozzle / bed). My best prints have used rafts on glass. When I remove the raft, I find that ca…
