Skip to main content
Skip to profile content
around 24 hrs work de rafting cleaning up & printing 3 parts in total 1st crank/pistons /conrods in one 2nd block 3rd lower case
-
For the 5th Gen it´s very unlikely, that the motor wire is broken, because it does not move at all (like on the 2x in X). You have a H-Bot Design Gantry with both steppers suited in the back without moving.
-
I have had erratic print behavior in the past on my 2X. It turned out that one of the wires in the wire harness to the stepper motor had broken, perhaps from fatigue. When the harness got to a certain position the motor would skips steps. Just a thought.
