-
Right hi guys I think it might be temps, I’m running sailfish, makerbot desktop all updated, and it does this for all prints well did, im using a new reel of blue pla exelvan. It started happening since the reel, I was normally running 210c but I tried 230 and it looked like it flowing better now wi…
-
here the picture [dsc_0002_1.jpg]
-
Well it can use repg sailfish and I use makerbot as well. I’ve tried Google but not much on it. Maybe you can’t do it.
-
Just got some today, for measuring the filament its around 1.8, 1.7. I’ve managed now to setup a pi with octoprint and enter in a command to feed through 100mm and then re measure what was left, the only thing now is where can I find the extruder feeding steps setting under makerware and or rep g, b…
-
I thought to strip one end down of the printer to see what state the rods were in and sure enough Chinese special bad workmanship came to light. The carriage rods gears were not aligned so moved them to be perfect where the belts now move perpendicular with each other ive levelled out the washers so…
-
Hi, I’ve check this and it is all tight Any other problems?
-
You may be right, ive looked at the left to right metal bars and the both look bent in the middle a tad, also the back one move a fair bit left to right when moved by hand looks like they are not fully in right on the bearings, ive removed the tensioner springs already and belts are OK not overly ti…
-
Hiya ive just tried 5% 10% and 20% on my y axis and printed the helper disk large and I cannot notice any difference its still showing as 1mm over on one axis, I changed these settings under the makerware software device preferences under Axis steps mm. Any more suggestions? thank you for your hel…
-
hiya thanks for the help, so at the moment I am just running a single nozzle due to my other one damaged (waiting on new one as backup), I have a sheet of glass which is 2 or 3 mm bigger than the standard ctc dual bed which is 230mm x 150mm, I only would like to have the bed (let me get this straigh…
![[dsc_0002_1.jpg]](https://www.3dhubs.com/talk/uploads/db5060/original/3X/4/3/43623cfd659db7869d3be6a242a888f0771dc6c2.jpg){kind=link}