-
You need to shorten the name of the file you send to the printer
-
Try load more filament to push the snapped through.
-
You could use PetG instead of ABS - the you don´t need printed bed…
-
I have The same printer and Love it. Had same problem before I did a bed leveling. Use the built in system to do a calibration. After that make print a square line 120x120mm 0.2 layer. If that gets even, try 0.1layer to 0.5 mm. Measure around the corners with calipers to check it’s 0.5. Otherwise tr…
-
I first level the print bed with the build in wizard. Then I print a big rectangle (120x120mm) 1 perimeter, 0.1 layers, 3-5 layer height. While printing check each layer sticking and looks the same in thickness. When ready loosen the printe and measure the height around each corner (remember the dir…
-
The added height from the tape probably helps solving the issue
-
Hi, The solution is One of This two or both: 1. Calibrate the level, don’t just trust the auto leveling. 2. Take 1 part glue for wood and 4 part water. Mix and distribut with a pencil and let it dry out. I have had lots of problem like this, tried glue and everything. But since leveling I don’t e…
-
Have you tried to calibrate the extrusion ratio?
