-
Thanks for your response. Sorry for the delayed answer. Yes, thats correct. One prints fine, anymore and I get a layer shift about 60% in. The object is 66.99mm(x) x 14.39mm(y) x 94.61mm(z - tall)… What do you think? I can try printing slower but really doesnt make sense. If it was a belt issue I …
-
I found one of the problems…for some strange reason I had Extrusion Multiplier set to 1.50. When I reset that to the default, everthing cleared up…thanks everyone!! The suggestion to set everything to default for Forge was the trick!
-
Thanks I’ll give it a try…Any particular brand of purple glue stick? Are you referring to the Elmer’s Disappearing Purple School Glue Sticks Just a clarification, the rest of the print looks fine. It’s the first few layers I’m worried about…Since many are suggesting to LOWER the bed temp to avoid t…
-
Just my newbie 2-cents, I noticed a problem with clicking when I leveled too close to my extruder. From my own personal experience, paper should be able to slide without ripping or grabbing too much when leveling…if its too tight, I get clicking on the first layer and barely any PLA extrusion.
-
Thanks everyone for the suggestions, please keep them coming. This community is amazing!! I’ll try to drop the temp of the extruder and plate and report later today. Some more info and concerns: I use Simplify3D and have tempered glass on my bed. My cruising speed is 1200. Fan starts at 100% after …
-
Thanks…the reason my bed was so high is because my prints keep curling as if its cooling too quick…any ideas how to lower the bed temp but prevent the bottom of the prints from curling?
-
Why is this still unpublished?
