-
What are you stocking right now? I’d also suggest stocking some Igus bearings, they’re so hot right now for making printers quieter.
-
I’d suggest a few brands then Hatchbox Colorfabb Mg chemicals (cheap and good enough) E3D (all of the products. Filament nozzles. Heater cartridges. Thermistor cartridges. ) Filaments.ca has their own brand. Perhaps reselling their stuff.
-
Where is your store? I’d love to be able to buy locally. Especially colorfabb
-
I would suggest doing it through the terminal. M212 Z M500 to save M501 to print current values Brook Drumm has a youtube video showing how to do it. It’s all here http://printrbot.com/project/simple-metal/
-
You may need to go through your Z calibration again. Sounds like your offset is too negative.
-
Do the auto leveling thing the other guy mentioned.
-
Try my FFF profile. Dropbox - Printrbot Simple Metal.fff - Simplify your life I’ve had more successful prints with that than any other software. I hope this helps.
-
Any reason you’re not sharing the name? " the 3D printer manufacturer based in Victoria " a bit vague.
-
That is a significantly better shipping cost.
-
I’m looking for some colorfabb 1.75mm filament PLA/PHA and/or nGen. I’m running out of the samples from the meetup and I can’t justify $60 for shipping from the Netherlands to buy it. Does anyone locally sell it?
-
Change “G28 X0 Y0” to “G28 X0 Y0 Z0” The auto leveling only works if z is leveled first. This might cause the head to crash into the plate. You will likely need to raise the height of the sensor. Check to see if the plate triggers the sensor by holding it under the sensor and looking to see if the L…
-
No matter what type of image I try to upload it tells me it’s too small. I uploaded one that was ~5500x4500 and one that was 1100x301 and both times I got the same error. [3D Hubs header image bug.gif]
![[3D Hubs header image bug.gif]](https://www.3dhubs.com/talk/uploads/db5060/original/2X/9/9ebdaf34b97ed2ebed37b837359f6c3e2aa17ed9.gif){kind=link}