-
There has be a lot of discussion of which firmware - Marlin or Repetier is better on a delta printer controlled by an 8bit (ATMEGA) Arduino controller. To this end I did my own tests: [Marlin vs. Repetier Firmware on a Delta 3D Printer] The second part compares the latest 1.1.8 Marlin…
-
It does not. However you can upload my configuration.h to the Repetier download page an configure the heated bed in the web interface. Then download it.
-
You can use the one above. Just read the description on how to change the height, radius and arm length. You can find those in the Marlin that Anycubic provide.
-
Try to download the Marlin firmware from here: Or the older versions from here: The file you need to open in the Arduino IDE is “Anycubic_Kossel.ino” it is located in: “Kossel files_20161116.rar\Eng-Kossel files 20161116\Firmware\For Linear and Pulley\” or “Firmware for linear and pulley-wi…
-
Here is my Repetier firmware for the Anycubic Kossel Linear: https://github.com/ruevs/repetier\_anycubic\_kossel Follow the directions for installing and configuring. It works perfectly for me. If you prefer Marlin - which I would not recommend - Repetier is better for deltas - then you can down…
-
Anycubic have released a modification on 2016-11-22: https://drive.google.com/drive/folders/0B8VIB533cgdMVUdCY0RXNEVzc0E They sent me the spacers after the fact and in the meantime I made my own by cutting 5mm sections from a 3mm internal, 4mm external diameter brass pipe. Mounting the linear sli…
