-
I purchased one of these last year and it now works with the SE series of uPrint printers. Its only $100.
-
Sounds like the PSU is dead but to make sure, check the voltage (120/240) going into the PSU. If its present, then check for fuses on the power supply itself. If those are good, then its a good bet that the PSU is faulty. Perhaps you can order one and replace it yourself?
-
Have you checked the internal power supply?
-
100% Agree with Chelsea Rae. First check all external connections. Then open her up and check internal connections starting with the power supply. Our Uprint started reporting sensor errors and it was eventually traced back to a single crimp connector with a broken wire on the power supply.
-
Service guide attached. Error code 14.67 Abort : Head temperature too high 1. Verify the TC and Liquefier Heaters are plugged in properly. 2. Check umbilical is connected properly. 3. TC Amp board is bad. Replace TC Amp Board. 4. Head Board is bad. Replace Head Board. 5. Replace the umbilical c…
-
What is the difference between the icons shown on the map? Some are orange houses while others including mine are a teal shopping cart. Also, there seems to be many participating hubs missing on the events page. Is it up to us to create a meetup and tag it with #3DPRINTINGDAY?
-
Nassau County Executive Edward P. Mangano announced that the Feb 23rd meeting of the Nassau County Inventors and Entrepreneurs Club will feature the founders of the largest 3D printing network in the world, 3dhubs.com The club, sponsored by the Nassau County Industrial Development Agency, will me…
-
Good point about the effects of print quality settings @3Dscaleworks. Looking forward to the improved costing algorithms in the future. Thanks to all for the feedback.
-
Prior to joinning 3DHubs, I charged an initial setup fee, plus the volume of material used but had a minimum charge per part. This helped me offset the additional time spent setting up multiple small parts, while helping me keep costs competitive for the larger parts. I’d like to see 3D hubs add a …
