-
Oh it’s just an extra check to make sure that there’s no issues at all with the filament but I agree that this is not going to solve the issues alone :). I work in the filament industry so I kinda have a standard list of like 30 points that I work through group-wise to pin down where the issues are. …
-
Alright looking forward to the feedback!
Regarding point 1; Even cheap filament can look great but what you don’t see if it has diameter tolerance issues. Therefore you would have to measure it at several points on the spool with a caliper. So you can never say that filament is fine just by lookin… -
Hi @federico3, Please check these 4 things: 1. Consistency of the filament diameter 2. Temperature variation; What is the off-set on your hot-end? 230 on your screen could be 215 or 245 etc. in real life with your machine 3. Are you certain that your PTFE is still in good condition (no brown par…
-
I’ve had the 3DKreator Motion for over 3 months now and it is indeed a workbeast! My job requires me to test a LOT with different filaments and I’ve yet had a material under 260c that did not print well. I’ve tested with: PLA, ABS, PET-G, HIPS, ABS+, PC-ABS, WOOD, METAL, CARBON FIBER, PVA, FLEX et…
-
What percentage hemp is in the filament? It doesn’t seem to be that much?
-
Ik zie een mooie kans voor het vernieuwde fablab om een positie te nemen?
