Skip to main content
Skip to profile content
-
I would recommend the following: - To high print temperature for your filament, try 190-200°C - layer height should be ok with 0.1 - but it looks like 0.4 - extruder width 0.48? are you sure? - infill with 20% should be allright (lower) - raise bed from 50 to 60° I would try to print it with C…
-
You should review you communication with your initial hubs as well I think. Seems like I’m not the only one who didn’t now that not talking to a robot means getting a “bad” rating.
