-
You’re welcome and when you start printing with the printer you’ll want to abandon the makerbot slicer if you haven’t already. When I switched over to sailfish, my printer would stop after about ten layers but it worked fine after switching to S3d.
-
You might want to make sure you uploaded the right version of sailfish (because you’re using a single extruder now) it might not have any effect on it but it could be a good idea to check and as for the part on using only the left you’d probably need to adjust your Toolhead offset in sailfish or the…
-
You might want to make sure you uploaded the right version of sailfish (because you’re using a single extruder now) it might not have any effect on it but it could be a good idea to check and as for the part on using only the left you’d probably need to adjust your Toolhead offset in sailfish or the…
-
Could anybody tell me how to connect a proximity sensor to a mightyboard on sailfish? and would i be able to use this sensor? https://www.amazon.com/gp/product/B00S50O152/ref=oh\_aui\_detailpage\_o00\_s00?ie=UTF8&psc=1
