-
Hi. Just basing this on the questions you are asking, doing this yourself is an option if you have a year or more in time to get up to speed. 3D printing isn’t like dropping bread into a toaster, pushing a button and voilla, you’ve got toast. Having said that, if you have an interest in 3D printing…
-
I had until recently a Flux 3d printer. It was a surprisingly good printer for the low Kickstarter cost, although the software is in Alpha stage and underwent many changes over my short ownership. There was a substantial learning curve to determine what combinations of settings and material produced…
-
Its hard to say without any dimensions, but I doubt that “railing-like” detail at the top would even be printed on an M2 or any FDM. Microns dont matter when details are smaller than the nozzle (.35mm standard…optional .25mm). If I was you Id send a small cross section of that part to a a hub with a…
