Peak Additive provides expert 3D printing and design services. We offer a wide range of thermoplastics for FFF technology and will advise the right material choice for your application upon request. There is no size limit for our capacity, let us build your ideas!
Peak Additive formerly operated out of Denver, Colorado leading the industrial way for Additive Manufacturing, and was featured in 3D Hubs’s “The 3D Printing Handbook” for a case study related to production based 3D printing for an electronics manufacturer. Peak Additive is now located in Moorpark, California to venture into new and exciting markets on the west coast.
-
This cannot be removed. Seam placement is a better method, but cheap slicing software usually doesn’t have those options.
-
This is normal for any FDM printer. That is a seam line created when the extruder tip starts and stops at a given point every layer.
-
You can try inserting the phone geometry into a solid block using assembly. Then edit the block in the assembly and select cavity and click on the phone geometry. Using then using a combination of the surface offest and split command you can have you inner phone geometry with a flat outer surface.
-
If the infill is 100% you need to reduce the cooling, therfore I would heat the build plate up even higher. At this point its trial and error until you get the right temp. Geometry and orientation are a big part of how your part shrinks. Using default settings almost never work. Good luck.
-
Make sure your build plate is heated to at least 110C. Go with 20% or less infill and use Kapton tape. Hairspray is good and the cheap way out, but I’ve found that Kapton works better and consistent -Peak Additive
-
Honestly, PC or Nylon are your best bet for a prosumer machine. If you want something that will last spend the money and get your part made out of ULTEM 1010. I know a few guys that use this under their Corvette and it works like a charm. -Peak Additive
-
There are not too many Thermoset resins that can take that kind of heat. Thermoplastics are the way to go.
-
I don’t quite understand what output bits are but if you mean components the creator pro is very customizable.
-
Which Flash Forge model do you have?
