Skip to main content
Skip to profile content
-
Probably it’s a problem with the heating process, try to replace the heater cartridge.
-
Yes, you can instead use a flash drive or print from your cloud services.
-
change the units from millimeters to inches or the opposite.
-
maybe some stripped wires cause the problem. I suggest replacing the control panel with a new one.
-
Definitely you have a print bed problem. 1- First check the print bed and see if it in its place. 2- try to level it. 3- use blue painters tape. 4- On Makerbot Desktop, after you insert the part use the center button first, then move it and rotate it as you like. [Screen Shot 2016-08-16 at 9.5…
-
HI, I have ( Makerbot Replicator 5thG ). I can help and print some parts for you if you are OK with PLA plastic.
