Skip to main content
Skip to profile content
A 15 year old entrepreneur who will design with given dimensions, and can print your amazing 3D prints.
-
I have a Robo 3D R1. I figured out the problem. The extruder had to be raised higher than with a typical filament. I also raised the print temperature to 220° C.
-
I have been trying to print with flexible filament, but I cannot figure it out. I had done one calibration cube, and it worked, but after that it quit working. I have found the problem in the extruder with the attached picture. It always prints a little at the start of the print, but stops. [image…
