Inconsistent print quality with Ultimaker 3

3D Printers

Jun 8, '17

Hi everyone, thank you again for all your comments. The quality of our print definitely improved! But we still have some problems with the quality of the keychain’s ring as you can see in the picture enclosed. We printed 4 Marvins at the same time and used the following settings: Layer height: 0…

Inconsistent print quality with Ultimaker 3

3D Printers

May 29, '17

Thank you very much for all your comments so far! We have already tried the Cura standard settings and had the same problems. We started with a printing speed of 55mm/s and then lowered it to 30mm/s, but still we had the same problems… We use Cura Version 2.5.0. Our filament is original Ultimaker…