Skip to main content
Skip to profile content
-
Thank you so much for sharing! This indeed looks _fantastic_. You’re tumbling with steelshot and water? Are you adding any polish to the mix? Have you tried ceramic media?
-
That’s great advice. Did you buy a thin veneer and clamp it with some small C-clamps? What kind of wood did you buy?
-
I recently exhausted my first roll of 1.75mm Taulman Nylon 618 with my Makerbot Replicator 2. I learned a lot about printing in this tricky material and wanted to share here, as I hadn’t seen anything on Talk as of yet. Taulman Nylon 618 is similar to cast Nylon 6/6. It’s tough, slippery (a low coe…
