-
It has been the plug on 5 different machines I have worked on.
-
If there are open analog pins on a Davinci board and you get the kit with amplifier then wire the signal wire from the amplifier board to the open analog pin then wire the power 5v and ground to the amplifier board. Then edit the temp table in FW.
-
If there are open analog pins on a Davinci board and you get the kit with amplifier then wire the signal wire from the amplifier board to the open analog pin then wire the power 5v and ground to the amplifier board. Then edit the temp table in FW.
-
Look at the pin.xlsx file, find an analog pin. Change firmware temperature pin # to match the analog pin #. I worked with Repieter to get this working via the Repieter configuration tool but you should be able to alter your firmware to this. You can probably get luc-github to help you, he is t…
-
Did you buy the kit that includes the amplifier board?
-
Have you "seasoned " the hotend? PLA is hard to extrude, use canola oil, wipe it on 2’ of filimant and feed it through hotend. Make sure the clamping force at your knurled wheel is not too loose or to tight, if it is to tight the filiment can be deformed into a shape that does not fit into the openi…
-
Install open source Firmware, buy petg filament, buy buildtak the correct size for your printer, start to enjoy printing.
-
Install opensource firmware so you can use other filaments, buy T-glase or Petg and you will start to live for the first time in your printing life. Very little warp, absolutely no layer delamination, prints at 230-250c, stronger than abs, no smells or vapor.
-
There is something called the coefficient of expansion, or, for you, things grow when they get hot. So to get an accurate measurement, the need to be at temperature is ideal.
