-
Hello, I had problems with the humidity yet. For me it was only when I had set the hoses wrong on the carriage. Since the process of the axes, the powder was whirled up and then has placed on the print head … Will the printhead get hot quickly? And are all druchköpfe affected? May I ask you where…
-
hello, have you ever cleaned or rinsed the pipes? Sorry for my english, google translator.
-
Hi, was the problem with the green solved? I have the same problem now. I always have white pimples on the models. These are always very expensive to remove. does anyone have a tip for me? Greetings, Jens
-
Hello kalgula20, There is also too little powder when aligning. I’m already going for it myself. Can I set that somewhere?
-
Hello, when it comes to auto alignment always comes the message: "can’t pick referece head " does anyone know what I need to do?
-
HI, could the problem be solved? I also have this problem Greeting Jenszzt
-
Hello? Is there no one left? Does anyone have a copy of flash drive? Or can anyone please help me?? My printer doesn’t want to work anymore.
-
Or does anyone have the Firmware 3.206 for me? Then I could play them again. You can do That with a USB Stick, right? The Flow of the Binder is super only the printer switches off the flow after some Time. Thank you for your Help
-
Hello everyone I have the following Problem: When I print comes the clear Binder normal. From about 50 Layers, the Binder is switched on and it only presses the colored Edge. The running through of the Binder is going well, in my Opinion. Can this be a Software Problem? I’ve got V 3.206 on it. Do…
-
Hello, I had the same thing that I had to press F1. An electronics engineer had then noticed that what had been adjusted in the bios. The start of the mainboard has been activated. But how he did that, I can’t say. So press F2 and see through.
-
Hallo, ich hatte das auch mal das ich F1 drücken musste. Ein Elektroniker hatte dann festgestellt das sich was im Bios verstellt hatte. Das starten des Mainbord wurde aktiviert. Aber wie er das gemacht hat kann ich nicht sagen. Also F2 drücken und mal durchschauen.
-
Hallo Frank, eine gute Frage. Ich bin nur im Forum um Probleme am Drücker zu lösen. Ich weiß auch nicht wie man hier starten kann. Gruß Jens
-
Thanks for the information Many greetings
-
There are many recipes on the net. You can experiment a lot. But you could also do an internship in a 3D printing house. There you could get your first experiences. Sorry if my engisch is bad - I write with the Google translator
-
Hello, I’m from Germany and print privately with a ZCorp 510. I mix in powder and binder myself. I scan persons with the Ipad 4 and the Isense. That makes cheap money. I started with a FreeSculpt 3d printer and the Kinect to scan. So start small and then get better and better. Greeting Jens B…
-
Hello, I wanted to ask if there is already Claren Binder for the Z510 recipes. I would be very happy to receive a message.
-
Hallo, mein 510er macht Zicken. Er druckte normal die ersten 15 Layer. Dann fuhren die Druckköpfe durch das Pulver - als ob die Layer- dicke sich geändert hat. Habe dann alles sauber gemacht und neu gestartet- nun kam die Meldung Printhead Power fail. Habe die Pogocard gereinigt und die Druckkö…
