-
Hi, Here is today’s attempt to get a successful print this time using uni’s ultimaker 3(the 2+'s where either being used or awaiting maintenance), it got most of the way through before for some reason no longer sticking and becoming the stringy mess at the top of the picture(it broke in half get…
-
Hi, The suggestion to cover at least the front panel appears to off improved the print some, still not perfect but heading in the right direction at least. would a raft work better then a brim to minimize the warping? attached is a couple of photo’s comparing the last print with the most recent …
-
Thanks for the suggestions, I will give them a try on my next attempt next time I’m at my uni’s makerspace. Filament brand is Aurarum. I have tried abs slurry but the print didn’t stick to it, I may not of used enough abs thanks again for the suggestions James
