Skip to main content
Skip to profile content
-
Hi Fabian, I must be using a little older ver. of the Slicer as some of the params I do not know. I also use 0.2 mm for standard prints which is completely satisfying, not need to go down to 0.15, could be a result of your setting… I’d start with adjusting the first layer until it looks like in t…
-
I would start with adding 30% fan after the two-three first layers, 50% fan speed for bridges, and leave the temp. If you lower the temperature as well, and you get a good result, you don’t know if its the lower temp or the fan that made a difference. I’m always editing one parameter at a time.
