Skip to main content
Skip to profile content
-
i did check it. it’s definetely a hardware issue because it offsets regardless of whether it’s online or offline. i also checked both encoders and they seemed fine without any powder debris or anything. i’m not sure what’s going on
-
@Jason_McMullan thanks!! i’ll check it and see how it goes
-
@chrisblanchard thanks a lot. you probably saved me from trouble, i’ll look into it right away
-
yes it does it just shifts its start and end on the axis a bit every time. i think it was serviced recently but not by me. thanks a lot, i’ll look into it. @PlastiPrint3D what would your guess be if it is a hardware issue?
