-
I had to replace the x-axis bearings because I used hair spray for so long, that the carriage could barely move. I use IGUS RJ4JP-01-08 now, but only for the x-axis. After putting everything back into place, I have Z-wobbles now on every print. They look like discrete lines all arount the print eve…
-
Thank you. I secured the shim using standard silicone glue. Now, I don’t have any more trouble. I think it moved. You can barely see what it is doing because of the housing. I had to remove the back side in order to secure it well.
-
Hi, thank you very much. Now looking back, I think it is vital to relief the stress on the cables. I use the cable support now. This is the one I chose: Flashforge creator pro estruders cable holder clip by Andicot - Thingiverse
-
I have problems with my extruder motor. It starts clicking after a while without any specific cause. I tried to change the stepper, then I swapped the drivers on the board, I tried to put the motor on the left of the two extruder slots. When I turn on the machine and feed filament, it can go for qu…
