Skip to main content
Skip to profile content
-
Where did you get new firmware? I only see the version from July on the Fusion3 site.
-
We also had issues getting the web interface working on our F400-S. The solution was to assign the printer a static IP address and then modify \sys\config.g on the printer’s SD card with the new network info. Here’s what that section of config.g looks like for my printer: ;*** Adjust the IP address…
-
I just started printing PETG (Atomic Filament clear) on my F400 and so far the S3D profile provided by Fusion3 has worked well. My only issue is that the purge blob at the beginning of the print keeps getting stuck to the hot block.
