-
Hi Try to lower temperature to 245,cover the printer with a towel to prevent the heat from getting out. Works for all my abs prints
-
You don’t need to cut the model, just add support at the bottom and it should be fine, br
-
Hi, Filament problems could be caused by inconsistent diametar, you could change the spool and try again. Try to push the filament trough by hand and you should get consistent flow, if not nozzle needs cleaning. You could thy the cold plug method for cleaning. Also try to tighten the part that holds…
-
We own one for 6months now, build is solid, it’s fast and reliable with few bugs in software but nothing major
-
Predlažem da jedna od tema bude cad programi, možda printanje sa supportom iako se to može uklopiti u pripremu modela za 3d ispis, lp
-
I printed with white PLA,two fans blowing from sides all the time.The problem was to cool this print so i reccomend you print two at the same time to allow for cooling and better adhesion
