-
I have had loads of problems with my Velleman printer including the ones that you are having. For sticking issues I finally went with a glass plate which I hold to the original bed with 4 small bulldog clips and I coat this with a strong hold hair gel. this works for me most of the time. For the fee…
-
I hope that you do not have any problems with your new printer but I would be prepared for some which have been mentioned on various forums. I would say that a glass bed is a must so that your prints will stick and also be very careful with the white PTFE part they break very easily. I have had lots…
-
My comments are based on personal experience. I was told that all support was through the velleman forum and was not given a tech support e mail address. I have posted on the forum several times and have never had a reply from velleman, it has always been other users that have helped me out. As for…
-
As you can see from the other posts this printer will need to be upgraded for you to get any good prints from it. I would not recommend this printer to anyone. I have had mine for almost a year now and have only just started to get good results after using most of the upgrades mentioned. Velleman s…
