-
I did put the clip in but when i went to take the filament out it pulled the tube up to the gear area so i was going to tear it down to inspect but i would prefer just to take it to someone that knew what they were doing
-
Andover. Have no problem driving the printer out to get it fixed
-
Robo r1 plus. I just installed the e3d v6 and the hot end seems to be blocked. The boden tube seemed to move so not sure if that caused the clog. Would need that fixed i would like to add 2 more fans to the set up. Software wise need the bed leveling fixed and adjusted. Is printing about an inch off…
-
Robo r1 plus. I just installed the e3d v6 and the hot end seems to be blocked. The boden tube seemed to move so not sure if that caused the clog. Would need that fixed i would like to add 2 more fans to the set up. Software wise need the bed leveling fixed and adjusted. Is printing about an inch off…
