Skip to main content
Skip to profile content
-
Well, it’s certainly possible - it’s a very large print area, and the bar that goes across could lower by a mm or two when the print nozzle is at the center of it. I actually have been noticing a similar issue with mine in the last couple days, but I’ve been trying Fleks3D plates, and I was chalkin…
-
When you say that the fourth control point isn’t good, what’s the specific issue? Is it too high in the middle, or too low? The Witbox has a super-thick glass plate, have you added anything to the top of it? (BuildTak, excessive glue, etc.)
