Cocoon Create doesn't print the center of the first layer

3D Printers

Feb 5, '19

Tried 215. I still have the same issue. It feels like at some point the filament doesnt go al the way in, so it doesnt supply the extruder with enough filament. Cause filament usually starts to go out at around 200 but after failed print nothing goes out and I have to manually push the filament in s…

Cocoon Create doesn't print the center of the first layer

3D Printers

Feb 5, '19

Yes I am using PLA plastic. temp used to be at 195 but 198 used to work with the same filament. I just started to have this problem now.

Cocoon Create doesn't print the center of the first layer

3D Printers

Feb 4, '19

Running 198°C and the printer has no mods so whatever came out of the box. Probably direct feed and I dont know about a tension adjustment

Cocoon Create doesn't print the center of the first layer

3D Printers

Feb 3, '19

Now it starts out alright but ends up going back to its problems halfway through… and if I manually push the filament through it goes through the nozzle with no problem [20190203_124921]

Cocoon Create doesn't print the center of the first layer

3D Printers

Feb 1, '19

I currently use a cocoon create 3d touch and sometimes the printer won’t fill the first layer’s surface at all. My prints start out fine with the outline but then it stops extruding filament while still moving around when printing the center parts. Please Help!!!