-
Hi Marius, The flowrate and filament diameter settings are all good to go it seems. I’ll check that all cables are properly connected when I get the chance. I’ve done the lower and raise test on multiple occasions - sometimes I see nothing, and sometimes I think I see tiny skips. But honestly, I ca…
-
Maybe the top of our print is curling up? That would make it seem as if thy extruder head were too low when in reality the printed material is too high… This print did have a lot of overhang which could have led to warping. We are also using a custom printed fan shroud to accommodate for having a la…
-
We are using the z-axis stabilizer, but I’ll check the set screws and see if they have any play.
-
Hi Ian, We received it assembled, but I’ll check those set screws and if they’re at all easy to take out I’ll apply threadlocker. Thanks!
-
Not sure why the image I attached is rotated… Can’t seem to upload it in any other manner…
-
As the other enthusiastic roommate and as somebody who has built a 3d printer before I’m inclined to stay away from build-your-own designs. The printer I built (about 4 years ago) was a RepRap Rapman printer and we had a lot of problems with it. After assembling it we were constantly fiddling with b…
