-
My rollers are the noise maker now. I have a drill press arriving today and will drill out some brass bushing to replace the roller bearings, hopefully this weekend.
-
If you find that you are printing air then you might have inconsistent filament diameter That can be an issue with the stock extruder. There is no tensioner for the stock extruder. it’s just a roller bearing and the stepper motor. The best thing for that is a new spring loaded extruder. This way the…
-
Remember that the printer uses 24v so maybe get a 10x40 PC fan and use a 12v adaptor. I used resistors to step down the 24v to 12 and used a amazingly quiet fan, Noctua 40x10mm. I replaced the fan cooling the stepper drives underneath as well. That fan dropped the printer from 70db to is it on?? You…
-
I’ve got a bad fixing block with my new printer and I can’t get the seller to send me a new one. Can the warranty center replace my bad part?
-
well I don’t have a pic with me at work but I can show you a print without the fan and one with and the difference was amazing. The active cooling fan I linked to only cooles the filament that leaves the hot end. It doesn’t cool the part on the bed. That would probably cause lots of peeling. The hea…
-
@RobertPaul This is my first print done 1 hour after unboxing the printer. 8-Bit Heart. Notice this is printed on the tape that the printer came with. PM me with your forex account.
This printer is good. To make it great it needs a few things. First would be for ABS an active post extruder fan. …
