-
I need some eager hubs willing to help with the 3D hubs table at the Orlando Maker Faire. The Orlando Maker Faire is on September 12th and 13th and it is held at the Orlando Maker Faire. I’m looking for at least 1-2 more hubs to help promote and share knowledge about 3d printing and 3D Hubs.
-
I want to submit a file to see how it looks when it’s printed with this printer [download_1.jpg]
-
Aloha Mr Cow, I had the same issue and it all came down to Z height (I had better luck at .2mm), fan on and slowing the print down at that fast of a layer. Want to make sure your extrusion rate and filament measurements are on too. 20-80% infill Hope that helps!
-
A lot of slicers have this “minimal layer time” setting. This prevents your printer going to fast on small parts like the loop and ‘locks’ the minimal time spend per layer. that might set you up
-
Heya! Do you have the original settings that you printed with? Once I get that I can help point you in the right direction. Looks pretty good minus the very end piece!
