Skip to main content
Skip to profile content
-
I have not had much luck printing nylon on blue tape. I glue a sheet of copy paper to the glass plate using gluestick. I usually set the bed temp to 90c. Also make sure your nylon is dry, if in doubt put it in the oven at 180F for 6 hours.
-
T-glass works best with thicker layer heights. I have actually had good luck with supports removing and leaving no after effects. I have printed a fair amount, a couple spools or so and found my ideal temp for printing is 228C. I typically use no layer fan, except for very small prints that would ot…
