-
i have some problems configuring marlin with my probe. i have the stock (blue) probe, it works but i can’t make the machine home at the center of the bed and the probe goes out of the bed when i try to auto level. here is my configuration.h file: /** * Marlin 3D Printer Firmware * Copyright (C)…
-
i got some abs today. this one was printed on 230c, bed was 90c. layer height was 0.2mm, 10% infill. wall thickness 0.8 print speed 40, travel speed 60. flow 90%, fan 50% overall im happy with it considering it’s abs, but i did have some under extrusion on the walls not sure why. [20170712_…
-
thank you everyone for the great help. i got some improvement from your suggestions. but i went through all the filament i had. and now im waiting for the filament i ordered from gearbest to arrive. then i will do some more experiments and report back. many thanks again. i see this forum has a v…
-
thank you i will try these and report back. i also had a problem that the extruder would stop heating mid print. but i fixed that by crimping the coupling realy hard. i think that was also part of the problem.
-
PLA at 200 degree
-
thank you for the reply i left the default 60/120 speed. what speed should i try?
-
hello everyone, a 3d noob here. i got a new anet a8 and trying to print i got a very bad result. i used cura with 0.1 mm layer height. and reprap as gcode flavor. everything else i left as default. you can see in the image the results are very bad, but only on the Z axis. the x and y axis are pr…
