Skip to main content
Skip to profile content
-
Hi 1. Have you noticed how close the adjusting screws are together , and that they are of set to one side of the print bed, this makes it very hard to adjust the bed level. And the print plate on mine slides about 1/16th back and forth on the “X” axis, so had to use tape to stop it sliding. 2. The…
-
Mine started Ok, 1. But soon found that the filament was being ground up by the feeder, no matter what tension I put on it it keep up doing it. 2. The head is so loose on the sliders it make the head chatter. 3. The temperature of the head keep going up and down eg. 280 to 250 to 180 to 250 etc, …
