Skip to main content
Skip to profile content
-
Leave the printer switched off and slowly turn the Z-axis manually (by hand).
-
Same with me, I typically run mine at max. 50 mm/s. Sometimes slow it down to 20 mm/s or less for optimum results with small parts.
-
Hi Richard, I think for PLA your general heat settings are a bit too high. I usually print PLA with 190° extruder and 60° heatbed temperature. This way it cools down faster. Also very helpful can be to cool the print with a fan. I am running the Sailfish firmware on my CTC and during the print I ca…
