-
Thanx James for the links.I will follow up the issue on those forums. Regards, Amos.
-
Let me look for the pictures for the prints I did in high resolution and I will upload in a while.
-
I use ABS Filament.and when I print standard quality or low,I don’t get this problem. and also I don’t think they are damp as I store them in a shelf and the room is not humid. As for the Makerbot,barely a year old.probably 11months @James_2 @ProdPoint
-
When I set the Makerbot to print in high resolution,hence high definition prints, the extruder stops extruding consistently and starts to “spit” after some time.then later stops completely. On reseting and trying again I still get the same problem over and over. Please assist
-
I own a Makerbot Replicator 2x in Nairobi,Kenya.Its in a Tropical Zone.
