-
Yes the brass extruder is held by a nut, you’ll need two wrenches, one to hold the extruder near the head and one to loosen the nut. You want just the brass piece, you won’t be able to pull the thermostat out without separating the aluminum assembly from the extruder head.
-
Yes, you have to disconnect the hot end (two fat red wires) I belive you’ll need an Allan wrench for that. Then there’s a thermostat that has two small wires, be careful not to yank those out, but that’s held by a small flat head screw and some high temp silicone (you’ll need to buy some high temp s…
-
What have you done to clean it? I’ve had similar issue, I end up taking the nozzle out and soaking it in accetone (accetone works as solvant for the ABS plastic). Whenever that didnt work I used a blow torch to burn off anything stuck in the nozzle. Hope this helps. Ohh and I’ve cleaned it with the …
-
I guess custumers can communicate whether or not they want additional service, at that point I can add it on there. Thank you so much!! Best Regards, Alex Materov
-
Hi Arnoldas, Sorry, I wasn’t able to locate “add additional costs” on the right side of the order, is this something that I need to do once the order has been placed and before print is complete? Also once I do add additional service and how much, does the customer at that point have the ability t…
-
Hi Arnoldas, Thanks for your prompt reply, I will definitely take a look at that. Thanks for your help
Kind Regards,
Alex -
We are given the option to add one of these as our Specialty, but how do you actually offer this service? Should one just include post production sanding and finishing in their price? For example instead of charging $0.50 per cm3 charge more.
