-
Hi, I think the cable is ok as after a while the head lové but as there is no Heat, filament is not Comines-Warneton out
-
Ok thanks What should be the resistance for the Heating cartridge? Is it possible to repair a defect motherboard? alain
-
I didn’t change thermistor. where is located this part. Where can I find new one?
-
No it don’t heat anymore. If I start a print it wait long time for heating, then it start to move but as no heat, there is no print. alain
-
I’ve I think 400 hours. It just stop while I was printing…
-
Hello Thanks for quick answer. The reading is working. it read ambiant temperature, 23 or 24° (a little optimistic) but the heating cartridge is not working, it seem there is no voltage on the 2 wires connect to the cartridge. alain
