Skip to main content
Skip to profile content
-
When I start my prints on my Anet A8 with Skynet firmware and auto leveling probe, after the auto leveling is complete the z axis moves up and back down again, and then moves to the starting point of the print. Here is my start GCODE: ;Sliced at: {day} {date} {time} ;Basic settings: Layer height:…
-
Is there any other way to dry out the filament, or is that the only option?
-
On my Anet A8 3D printer, every few prints, the filament snaps off, and I have to reload the filament. Do you have any solutions?
