Zortrax M200

[Christian_CAD]

Hi. I was wondering if any of you have any experience with Zortrax M200 prints letting go of the platform during prints? Do i set the fan to 0 of what do i do?

[JulieSillam]

I’m sure that @improto3D could give you some tips

[Christian_CAD]

I will write @improto3D and see what they say. Thanks

[JulieSillam]

You’re welcome

[Christian_CAD]

So @improto3D have you seen this befor? It happens everytime on a big print, with or without the fan. What to do?

[key23d]

Sorry Copenhagen, I don’t have any experience with Zortrax.

Kind regards, Guy

[Christian_CAD]

The solution was abs slury.

[Gfisherwils]

@jayceekeys is firing some great prints out with his Zortax any advice?

[ncapaldi1985]

I use a glue stick to hold my prints down works great. Got it off amazon. its UHU stic.

[FinalMadness]

You can sand the plate with a 320-400 grit sandpaper until the surface of the plate is matte. Sitecovers can help against warping.